Main Bearing Cap Removal; Crankshaft Removal; Piston Separation From Connecting Rod - Mitsubishi S3L Service Manual

DISASSEMBLY
t
Figure 58 Removing main bearing caps
t
Figure 59 Removing crankshaft
t
Figure 60 Piston pin setting tool
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
Cylinder Block, Crankshaft, Pistons

16.7 Main bearing cap removal

1. Lay the cylinder block with its bottom (oil pan) side
up.
2. Remove the bolts that hold the main bearing caps
in position. Remove the caps.
3. Remove the front and rear bearing caps with a
sliding hammer.

16.8 Crankshaft removal

Remove the crankshaft.
CAUTION
Do not cause damage to the bearings.
Put identification on each main bearing as to its
location in the engine.
16.9 Piston separation from
connecting rod
1. Use Piston Pin Setting Tool (31A91-00100)
(special tool) to separate the piston from the
connecting rod.
ENGLISH
and Oil Pan
NOTE
55 / 195