Installing Valve Block; Cylinder Head Gasket Installation; Cylinder Head Installation - Mitsubishi S3L Service Manual

CYLINDER HEAD AND VALVE
MECHANISM
Figure 158 Installing valve block
Figure 159 Putting cylinder head gasket
Figure 160 Installing cylinder head
100 / 195 100 / 195
Guide bolts
Guide bolts

22.4 Installing valve block

Put compression on the valve spring with a valve lifter
and install the block in position on the valve top.
CAUTION
Do not put excessive compression on the valve
spring. This can cause the retainer to hit and damage
the stem seal.
22.5 Cylinder head gasket
installation
1. Thoroughly clean the top faces of the cylinder
block and pistons.
2. Install two guide bolts (M10 x 1.25) in the bolt
holes in the cylinder block.
3. Put a new cylinder head gasket in position on the
cylinder block, making sure the guide bolts are all
in alignment with their respective holes in the
gasket.
CAUTION
Do not use any gasket adhesive or other substances
on the top face of the cylinder block.

22.6 Cylinder head installation

Put the cylinder head in position on the cylinder block,
making sure the guide bolts are all in alignment with
their respective bolt holes in the head.
ENGLISH
Service Manual Mitsubishi SL-Series diesel engines
ASSEMBLY
Version 08/2004