Table of Contents
Advertisement
11. Connect a voltmeter between the No. 11 terminal of
gauge assembly connector B (22P) and body
ground. Turn the ignition switch ON (II), and
measure voltage. There should be battery voltage.
G A U G E A S S E M B L Y C O N N E C T O R B ( 2 2 P )
12. Replace the No. 9 (7.5A) fuse, and check to see if
the S R S indicator light comes on.
Does the SRS indicator
light come on?
Y E S - T h e system is OK at this time.B
NO —Short to ground in the driver's under-dash
fuse/relay box No. 9 (7.5A) fuse line; refer to the
"Electrical" section, then continue
troubleshooting. •
S
P
1
2
/
4
5
X
6
7
8
9 10
11 12
/ / /
16
17 18 19 20 21 22
Y E L
W i r e s i d e o f f e m a l e t e r m i n a l s
Is there battery
voltage?
Y E S - F a u l t y S R S indicator light circuit in the gauge
assembly, or poor contact at gauge assembly
connector B (22P) and the gauge assembly; if the
connection is OK, replace the gauge assembly. •
NO —Open in the driver's under-dash fuse/relay
box No. 9 (7.5 A) fuse line, open in the Y E L wire of
dashboard wire harness A. If the driver's under-
dash fuse/relay box is OK, replace dashboard wire
harness AM
(cont'd)
23-267
Advertisement
Table of Contents
Troubleshooting
