Adjusting The Wide/Narrow Knobs - Paxar 9830-CL Operator's Handbook Manual

A d j u s t i n g t h e W i d e / N a r r o w K n o b s
The printer is factory-set to use narrow supplies. In most cases,
the narrow setting does not need to be changed. However, you
should change the setting to wide if you are using custom
supplies or supplies wider than two inches. For supply that is
more than two inches wide, adjust the knobs to the wide setting.
For supply that is two inches wide or less, adjust the knobs to the
narrow setting.
Both knobs must be adjusted to the
same position.
Make sure the narrow/wide knobs are set correctly for your
supply. If you are not sure which setting to use, try the narrow
setting first and then check the print quality. If the printing is too
light, use the wide setting.
For wide supplies,
push down and turn
the wide/narrow
knobs clockwise with
a screwdriver. For
narrow supplies,
turn the wide/narrow
knobs
counter-clockwise
with a screwdriver
until it pops back up.
The adjustment is shown in the wide position.
Care and Maintenance 4-9