Adjusting Wide/Narrow Knobs - Paxar Monarch 9825 Quick Reference

Feed the backing paper over the peel bar.
3.
Feed the backing paper through the lower opening of the exit cover. Close the
4.
exit cover. Pull down firmly on the backing paper to remove any slack.
Peel
Bar
Lower
Opening
When removing the backing paper, pull up across the saw-toothed tear
edge. Make sure the backing paper tears at the edge.
Close the printer's cover.
5.
Press Feed/Cut to position the supply under the printhead.
6.
A d j u s t i n g t h e W i d e / N a r r o w K n o b s
You may need to adjust the two wide/narrow knobs according to the width of your
supply. For supply that is more than two inches, adjust the knobs to the wide
setting. For supply that is two inches or less, adjust the knobs to the narrow
setting. For linerless supply, use the narrow setting (knobs are up).
You must adjust both of the knobs to the same position.
If you experience ribbon smudging in cold, dry
environments, adjust the wide/narrow knobs to the
wide setting.
For wide supplies, push down and turn the
wide/narrow knobs clockwise with a screwdriver.
For narrow supplies, turn the wide/narrow knobs
counter-clockwise with a screwdriver until it pops
back up.
The adjustment is shown in the wide position.
6
Tear
Edge
Backing
Paper