Connecting The Power Cable - Paxar 9830-CL Operator's Handbook Manual

A u d i e n c e
The Operator's Handbook is for the person who prints and applies
labels.
U n p a c k i n g t h e P r i n t e r
After you unpack the printer, you should have: a 9830CL printer,
power cord, and a ribbon take-up core (may already be on
take-up reel).
Keep the box and packaging material in case the printer ever
needs repair.
Power cords are not supplied with 230-volt printers. You need to
purchase a power cord separately. The power cord requires IEC
320 STD C13 end finish for the printer interface and it must meet
requirements for 1.6 Amps at 115VAC and 1 Amp at 230VAC.
C o n n e c t i n g t h e P o w e r C a b l e
To connect the power cable:
1. Plug the power cable
into the socket. Plug
the other end of the
cable into a grounded
electrical outlet.
2. Turn on the printer.
Press ( I ) to turn on
and ( O ) to turn off the
printer.
For information about
replacing the fuse, see
Chapter 4, "Care and
Maintenance."
1-2 Getting Started
Power Cable
goes here