Function List - Mitsubishi Electric MELSERVO MR-J2S- A Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.4 Function list

The following table lists the functions of this servo. For details of the functions, refer to the reference field.
Function
Position control mode
Speed control mode
Torque control mode
Position/speed control change
mode
Speed/torque control change
mode
Torque/position control
change mode
High-resolution encoder
Absolute position detection
system
Gain changing function
Adaptive vibration
suppression control
Low-pass filter
Machine analyzer function
Machine simulation
Gain search function
Slight vibration suppression
control
Electronic gear
Auto tuning
Position smoothing
S-pattern acceleration/
deceleration time constant
Regenerative brake option
Brake unit
Description
This servo is used as position control servo.
This servo is used as speed control servo.
This servo is used as torque control servo.
Using external input signal, control can be switched
between position control and speed control.
Using external input signal, control can be switched
between speed control and torque control.
Using external input signal, control can be switched
between torque control and position control.
High-resolution encoder of 131072 pulses/rev is used as a
servo motor encoder.
Merely setting a home position once makes home position
return unnecessary at every power-on.
You can switch between gains during rotation and gains
during stop or use an external signal to change gains
during operation.
Servo amplifier detects mechanical resonance and sets filter
characteristics automatically
vibration.
Suppresses high-frequency resonance which occurs as servo
system response is increased.
Analyzes the frequency characteristic of the mechanical
system by simply connecting a MR Configurator (servo
configuration) software-installed personal computer and
servo amplifier.
Can simulate machine motions on a personal computer
screen on the basis of the machine analyzer results.
Personal computer changes gains automatically and
searches for overshoot-free gains in a short time.
Suppresses vibration of 1 pulse produced at a servo motor
stop.
Input pulses can be multiplied by 1/50 to 50.
Automatically adjusts the gain to optimum value if load
applied to the servo motor shaft varies. Higher in
performance than MR-J2 series servo amplifier.
Speed can be increased smoothly in response to input pulse.
Speed can be increased and decreased smoothly.
Used when the built-in regenerative brake resistor of the
servo amplifier does not have sufficient regenerative
capability for the regenerative power generated.
Used when the regenerative brake option cannot provide
enough regenerative power.
Can be used with the MR-J2S-500A to MR-J2S-22KA.
to suppress mechanical
1 - 6
(Note)
Reference
Control mode
Section 3.1.1
P Section 3.4.1
Section 4.2.2
Section 3.1.2
S Section 3.4.2
Section 4.2.3
Section 3.1.3
T Section 3.4.3
Section 4.2.4
P/S Section 3.4.4
S/T Section 3.4.5
T/P Section 3.4.6
P, S, T
P Chapter 15
P, S Section 8.5
P, S, T Section 8.3
P, S, T Section 8.4
P
P
P
P Section 7.5
P Parameters No. 3, 4
P, S Chapter 7
P Parameter No. 7
S, T Parameter No. 13
P, S, T Section 13.1.1
P, S, T Section 13.1.2