Ride Motor Installation - Yamaha Waverunner VXS VX1800 Service Manual

10. Remove the RiDE motor "1".
1
4

RiDE motor installation

1. Hold the RiDE motor "1" at the installation
position of the hull.
1
2. Install the plate "1", and then tighten the
RiDE motor nuts "2" and RiDE motor bolts
"3" to the specified torque in the order [1],
[2], and so on.
1
2
3. Install the shift arm "1" and trim arm "2",
3
4. Adjust the length "a" of the trim rod "1".
• The trim rod joint must be screwed in
more than 8 mm (0.31 in).
• The shift rod joint must be screwed in
more than 9 mm (0.35 in).
3
5. Turn the trim rod joint 180° so that the 2
2
6. Adjust the length "c" of the shift rod "3".
8-28
[4]
[3]
[2]
RiDE motor nuts "2"
17 Nm (1.7 kgf·m, 12.5 ft·lb)
RiDE motor bolts "3"
17 Nm (1.7 kgf·m, 12.5 ft·lb)
and then tighten the shift arm bolt "3" and
trim arm bolt "4" to the specified torque.
4
Shift arm bolt "3"
11 Nm (1.1 kgf·m, 8.1 ft·lb)
Trim arm bolt "4"
11 Nm (1.1 kgf·m, 8.1 ft·lb)
holes "b" face in the opposite directions,
and then tighten the locknut "2" to the
specified torque.
RiDE motor
[5]
3
2
[1]
3
1
2