Yamaha Waverunner VXS VX1800 Service Manual page 154

1
2
2. Clean the tapered portion "a" of the crank-
shaft and inner surface "b" of the flywheel
magneto "1".
3. Install a new Woodruff key "2" and the fly-
wheel magneto "1".
2
b
1
4. Install the transfer shaft "1".
1
5. Hold the flywheel magneto "1" using the
special service tools "2" and "3", and then
tighten the transfer shaft "4" to the speci-
fied torque using the special service tool
"5".
1
2
2
a
A
5-63
1
2
4
5
4
5
Shaft holder "2"
90890-06721
Shaft holder "2"
YW-06721
Drive handle "3"
90890-06722
Drive handle "3"
YW-06722
Crankshaft holder "5"
90890-06732
Crankshaft holder "5"
YW-06562
Transfer shaft "4"
50 Nm (5.0 kgf·m, 36.9 ft·lb)
6. Using the hexagonal portion of the special
service tool "1" as reference, make marks
on the special service tool "2" at 0°, 60°,
and 120°.
7. Make a mark "a" on the transfer shaft "3"
where the shaft is aligned with the 0° mark
on the special service tool "2".
TIP:
The angle from one corner of the hexagonal
head of the special service tool "1" to another
corner is 60°.
Generator cover
3
1
2