Bilge strainer check
1. Check the bilge strainer. See "Jet vacuum
bilge draining system check" (3-10).
Transom plate installation
1. Clean the mating surfaces of the transom
plate "1".
2. Apply silicone sealant to the mating sur-
face of the transom plate "1".
3. Install the transom plate "1", washers "2",
and "3", and then tighten the nuts "4" to the
specified torque.
2
4
3
4
Transom plate nut "4"
26 Nm (2.6 kgf·m, 19.2 ft·lb)
1
6-18
Transom plate and hoses