Remote Control System; Remote Control Transmitter Check - Yamaha Waverunner VXS VX1800 Service Manual

Remote control system

Remote control transmitter check

1. Push the unlock button "a". The buzzer
sounds 2 times, and then check that the
"UNLOCK" indicator light "b" comes on.
2. Push the unlock button "a" for more than 4
seconds. The buzzer sounds 3 times, and
then check that the "L-MODE" indicator
light "c" comes on.
3. Push the lock button "d". The buzzer
sounds once, and then check that the "UN-
LOCK" indicator light "b" goes off.
TIP:
While the engine is running, input from the re-
mote control transmitter is not received.
d
b
Number of beeps
1 beep
2 beeps
3 beeps
a
c
Yamaha Security
System mode
Lock
Unlock
(normal mode)
L-MODE
(low-rpm mode)
4. Loosen the screws "1" in the order [1], [2],
and so on, and then remove the transmit-
ter cover "2".
Do not touch the internal parts except the
battery.
[4]
2
[1]
[5]
5. Remove the battery (CR2016) "1".
Do not touch the battery directly using your
hands. Use a pair of non-conductive twee-
zers to replace the battery.
6. Measure the battery voltage. Replace the
remote control transmitter battery if below
specification.
TIP:
Refer to local hazardous waste regulations
when disposing of transmitter batteries.
Rating
3 V
7. Install the battery (CR2016) "1" and trans-
mitter cover "2".
7-37
Remote control system
[6]
1
[2]
[3]
1