Cutter Deck Specification; Recommended Lubricants; Cutting Performance (Area) - Ransomes HR3300T Safety, Operation & Maintenance Manual

4 SPECIFICATION

4.7 CUTTER DECK SPECIFICATION

Construction
Blade Length
Number of Blades
Blade Tip Speed
Width of Cut
Height of Cut
Height of Cut Adjustment Front
Height of Cut Adjustment Rear
Anti Scalp Roll
Transmission

4.8 RECOMMENDED LUBRICANTS

Engine oil: Should be to MIL-L-2104C or to A.P.I.
Classification CD grades. [10W-30]
TEMPERATURE
Above 25°C (77°F)
0°C to 25°C (32°F to 77°F)
Below 0°C (32°F)

4.9 CUTTING PERFORMANCE (AREA)

152 cm Deck
2.46 hectares/hr. at 18 km/hr.
160 cm Deck
2.58 hectares/hr. at 18 km/hr.
SAFETY, OPERATORS & MAINTENANCE MANUAL
152cm Deck
Heavy duty welded pressed steel construction
533mm
4463 m/min
1524mm
Three antiscalp rollers on front of deck and four antiscalp rollers on rear of
deck.
By individual hydraulic motor to each cutter blade.
VISCOSITY
SAE30 or
SAE10W-30 or SAE10W-40
SAE20 or
SAE10W-30 or SAE10W-40
SAE10W or
SAE10W-30 or SAE10W-40
160cm Deck
559mm
3
4630 m/min
1600mm
25mm - 115mm
Castor wheels with spacers.
Multi-hole plates and pins.
Hydraulic Oil: Shell Tellus 46 (ISO VG 46) or
equivelent mineral oil
or Greenscare 46 (ISO VG 46) Bio
Degradable Oil or equivelent
Grease: Shell Darina R2, or equivalent.
183 cm Deck
2.96 hectares/hr. at 18 km/hr.
10% allowance is included for normal overlaps and
turning at the end of each cut.
183cm Deck
635mm
5318 m/min
1828mm
en-13