7
OPERATION
4.
Move the throttle control lever to the SLOW position.
5.
Turn the ignition key to OFF.
NOTE:
In an emergency the engine can be stopped by depressing the emergency stop button (Optional) situated
on the front of the instrument panel.
7.10 UNBLOCKING CUTTER DECKS
1.
Switch off cutter deck, lift out of work and move
machine to flat level ground.
2.
Switch engine off and remove the ignition key.
3.
Pivot deck see section 9.4.
4.
Using a piece of wood and personal protective
equipment e.g. eye protection and gloves,
7.11 TRANSPORTING ON A TRAILER
The machine is fitted with tie-down loops front (A) and
rear (B). Always tie down the machine securely to the
trailer.
Always follow any recommendations for maximum
trailer weights given in your towing vehicles handbook.
Never exceed the maximum gross weight shown on
the trailer plate.
Always read the trailer manufactures and towing
vehicle manufactures handbooks before towing.
7.12 SLINGING THE MACHINE
When slinging the machine a set of four damage free
wheel clamps should be used, similar to the one
shown, in conjunction with a certified lifting frame. For
more information go to www.tipnlift.co.uk.
SAFETY, OPERATORS & MAINTENANCE MANUAL
remove blockage.
5.
Check blades for damage and replace if
necessary.
6.
Put deck back into operating position see section
9.4.
7.
Start engine and decks to check for correct
operation.
B
A
en-39