Throttle Rod - Stihl MS 261 User Manual

10.3.4 Throttle Rod

– Remove the throttle trigger,
b 10.2
– Remove the baffle, b 12.3
Models with heating
: Pull the wire (1) out of the
guide (arrows).
All models
: Pry the filter base (1) out of the
buffer (2).
MS 261, MS 261 C
: Swing the filter base (1) in
direction of throttle trigger until it
is clear of the studs.
1
1
– Swing the filter base (1) in
direction of throttle trigger until it
is clear of the studs.
: Swing the filter base (1) in
direction of ignition side and rest
2
it against the stud (arrow).
1
: Pry the throttle rod (1) out of the
carburetor carrier (2).
1
: Pull the throttle rod in the
: Rotate the throttle rod (1) about
– Check the throttle rod and
2
1
1
direction of the rear handle until
its bent end (1) is at the
opening (arrow).
90° counterclockwise. Pass the
throttle rod (1) through the
opening (arrow) in the direction
of the tank housing and remove
it.
replace if necessary
1
93