Stihl MS 261 User Manual page 62

1
: Push the contact spring (1) onto
the ground wire (2).
: Position the short circuit wire (3)
so that it is above the ground
wire's flag terminal (arrow).
– Fit the contact spring, b 7.7.4
– Install the filter base, b 12.3
: Pass the ring terminal (1) through
the opening (arrow) in the filter
base.
MS 261, MS 261 C
1
3
2
– Place the switch shaft in position.
: Position the short circuit wire (1)
behind the tab (arrow).
: Position the ring terminal (1) so
1
that the gap in the ring faces
down.
: Push the ring terminal (1) onto
the peg (arrow) as far as stop.
1
: Push the short circuit wire (1) into
the guides (arrows).
– Install the switch shaft, b
: When installing the switch shaft,
lift the contact spring (1) a little
– no more than 2 mm.
1
: Check operation.
– Short circuit wire's ring terminal
must touch the contact
spring (arrow) in position "
– Reassemble all other parts in the
reverse sequence.
b 10.1
1
0
".
61