Stihl MS 261 User Manual page 64

The tab (arrow) on the contact
spring (1) must locate securely on
the edge of the filter base.
– Install the filter base, b 12.3
1
2
The short circuit wire (1) must be
above the ground wire's insulated
flag terminal (2).
– Fit the short circuit wire in the
switch shaft, b 7.7.2
– Install the switch shaft, b 10.1
1
: When installing the switch shaft,
lift the contact spring (1) a little
– no more than 2 mm.
MS 261, MS 261 C
1
: Check operation.
– Short circuit wire's ring terminal
must touch the contact
spring (arrow) in position "
– Reassemble all other parts in the
reverse sequence.
0
".
63