Throttle Trigger/Lockout Lever - Quickstop Super - Stihl MS 261 User Manual

2
1
: Push leg (1) of torsion spring in
direction of rear handle.
: Push the lockout lever (2) into its
mounts (arrow).
1
: Rotate the lockout lever (1) in
direction of rear handle and
engage the torsion
spring (arrow).
The lockout lever (1) may pop out.
2
: Attach the throttle rod (1) to the
trigger (2) and fit it in the
guide (arrow).
MS 261, MS 261 C
: Engage tabs (2) of handle
molding (1) in the
openings (arrow).
– Push down the handle
molding (1) until it snaps into
position.
– Check operation.
– Reassemble all other parts in the
reverse sequence.
10.3 Throttle Trigger/Lockout
Lever – QuickStop Super
1
1
1
: Push the tabs (1) apart and
through the tank housing.
1
1
2
: Remove the handle molding (1).
: Take the throttle rod (1) out of the
guide (arrow) and disconnect it
from the throttle trigger (2).
: Use a drift (2) to drive out the
pin (1).
2
1
2
1
89