Stihl MS 261 User Manual page 108

1 2
– Use STIHL press fluid to simplify
assembly, b 15
: Press the grommet (1) fully into
the bore from the underside.
: Pull the wiring harness through
until the protective tube (2) butts
against the grommet.
2
a
1
The grommet (1) must be properly
seated in the bore.
: Line up the grommet (1) so that
its holes (arrow) are at an angle
of a = 90° to the cable guide (2).
MS 261, MS 261 C
: The wiring harness must be
properly seated in the guides on
the tank housing, press it firmly
into the guides if necessary.
1
: Push the fuel hosea (1) through
the opening (arrow) on the
underside of the air guide shroud.
: Push the air guide shroud (1) into
its seats (arrows).
1
2
: Press the air guide shroud (1)
into its seat until the tab (2) snaps
into place.
1
: To simplify assembly, lift the
bottom of the air guide shroud (2)
slightly during the following steps.
: Push the tab (1) towards the
clutch side and under the edge of
the housing (arrow).
2
1
1
: Push the lugs (2) of the air guide
shroud (1) into their
seats (arrows).
2
2
107