Models With Heating - Stihl MS 261 User Manual

2
1
: Push the lugs (2) of the air guide
shroud (1) into their
seats (arrows).
1
3
– Place the air guide shroud (1) in
position.
: Insert and tighten down the
screw (2) firmly.
– Fit a new fuel suction hose (3),
b 12.11.3
2
1
3
: Push the connector (1) with fuel
return hose (2) into the fuel return
hose (3) so that the
contours (arrows) are in
alignment.
104
2
1
2
: Push the fuel return hose (1) into
the guides (arrows).
: Position the fuel return hose (1)
so that it is beside the short circuit
wire's grommet (2).
2
Do not kink or pinch the fuel return
hose.
1
: Lift the air guide shroud (1) a little
and place the ignition lead (2) in
the guide
– take care not to distort the air
guide shroud.
– Press the ignition lead (2) fully
into the guide.
– Reassemble all other parts in the
reverse sequence.
12.4.2 Air Guide Shrouds –

Models with Heating

– Remove the fan housing, b
– Remove the filter base, b 12.3
– Remove the throttle rod,
b 10.3.4
– Remove the carburetor, b 12.5
– Remove the carburetor carrier,
b 12.8
– Remove the ignition module,
b 7.3
– Remove the flywheel, b 7.6
– Remove the short circuit wire,
b 7.7.2
2
1
: Take the pin and socket
connector with insulating tube (2)
and generator wire (1) out of the
guides (arrows).
MS 261, MS 261 C
b 8.2
2