Stihl MS 261 User Manual page 91

2
1
: Remove the throttle trigger (1)
with torsion spring (2).
2
1
– Check the throttle trigger (1) and
torsion spring (2) and replace if
necessary
Installing
1
: Attach the torsion spring (1) to
the trigger (2) – note the installed
position (arrow).
90
1
: Place the throttle trigger (1) in the
rear handle so that the leg of the
torsion spring locates against the
handle (arrow) and the holes in
the throttle trigger and handle are
in alignment.
2
1
Brake cable must be in the handle
housing guide below the drift
– take care not to damage the brake
cable.
2
: Use a drift (2) to center the
throttle trigger (1).
: Drive home the pin (3) until it is
recessed by same amount at
both sides.
: Attach the throttle rod (1) to the
trigger (2) and fit it in the
guide (arrow).
: Engage tabs (2) of handle
3
molding (1) in the
openings (arrow).
– Press the lockout lever down.
– Push down the handle
molding (1) until it snaps into
position.
– Check operation.
– Reassemble all other parts in the
reverse sequence.
2
1
1
2
MS 261, MS 261 C