Stihl MS 261 User Manual page 145

1
: Pull the wiring harness (1) out of
the guides (arrows).
1
: Take the wiring harness (gray
wire) connector with insulating
tube (1) out of the
guides (arrows).
1
: Push back the insulating tube (1)
in the direction of the wiring
harness and separate the pin and
socket connector.
– Remove the wiring harness.
144
1
3
2
: Pull the insulating tubes (2) off
the wiring harness.
: Check the wiring harness (3) and
grommet (1) and replace if
necessary.
Installing
In all the following procedures:
: Insulating tubes must be
centered on the pin and socket
connectors and cover them
completely
to avoid the risk of a short circuit.
: Push the pin and socket
connector together
– total length of pin and socket
connector a = max. 30 mm.
1 2
2
3
: Fit the insulating tube (2).
: Position the grommet (1) so that
the recess (arrow) points towards
the heat shrink tube (3).
1
The black wire of the front handle
heating element must be seated in
the guides.
: Position the wiring harness (1)
with heat shrink tube against the
guide (arrow).
MS 261, MS 261 C
2