Carburetor - Stihl MS 261 User Manual

: Center the connector and
insulating tube (1) in the
guide (arrow).
: Press the generator wire and
wiring harness into the
guides (arrows).
: Push the pin and socket
connector with insulating tube (1)
into the guide (2).
Generator wire (1) must be seated
at the bottom of the recess (arrow).
MS 261, MS 261 C
– Install the ignition module, b
– Install the short circuit wire,
b 7.7
1
– Install the carburetor, b 12.5
– Reassemble all other parts in the
reverse sequence.
12.5

Carburetor

– Remove the filter base, b 12.3
– Open the fuel tank cap and drain
the fuel tank.
– Collect the fuel in a clean
1 container, b 1
2
Disconnect the fuel hose only when
the tank cap is open.
: Push the fuel hose (1) back a
little – the fuel hose is
disconnected.
1
b 7.3
1
Models with handle and
carburetor heating
1
: Remove the heating element (1).
: Remove the wire (1) from the
guides (arrows).
– Pull the carburetor (2) out a little.
: Push the insulating tube (1) in the
direction of the thermostatic
switch and separate the pin and
socket connector.
1
2
1
109