Leveling The Unit - Precor TRM 800 Series Assembling And Maintaining Manual

Assembling the Treadmill
5. Position the hood so that its screw holes line up correctly
6. Insert one ¹ ₄-inch × ³ ₄-inch panhead self-tapping screw
7. Insert one ¹ ₄-inch × 1¹ ₂-inch panhead self-tapping screw
8. Insert one ¹ ₄-inch × ³ ₄-inch panhead self-tapping screw
9. Tighten all six screws securely using a #3 Phillips

Leveling the Unit

The treadmill deck must be absolutely level from side to side
to keep the belt in alignment and ensure proper operation. If
the load is not equally distributed across the treadmill deck,
users may feel excessive vibration or observe it at the
console. You must make sure the deck is level before allowing
anyone to use the treadmill.
Important: Observe the following precautions throughout this
procedure:



with the holes on the base of the treadmill.
Figure 17: Hood installation and attachment
into each of the two side holes. Partially tighten both
screws.
into each of the two outer holes on the front of the hood.
Partially tighten both screws.
into each of the two inner holes on the front of the hood.
Partially tighten both screws.
screwdriver, starting with the front screws.
Adjust only one rear foot at a time.
Do not extend the adjustable feet more than ³ ₄ inch (2 cm).
Install the unit only on a stable, even surface. Adjusting the
rear feet cannot compensate for variations in the surface
under the unit.
31