Completing Assembly; Attaching The Stop Key; Removing The Protective Film; Leveling The Treadmill - Precor PRECISION SERIES Quick Start Card

TRM 400 Series Assembly Guide

Completing Assembly

Once initial assembly is complete, there are a few things to do before the treadmill
can be used:

Attach the stop key

Remove protective film

Level the treadmill

Check the alignment

Adjust the running belt

Break in the equipment

Attaching the Stop Key

The magnetic stop key fits into the nest on the stop switch assembly at the base
of the console.
Figure 22: Stop key placement
For more information on using the emergency stop function and the safety clip,
see the product Owner's Manual.

Removing the Protective Film

The treadmill ships with a protective film over the Precor logos and on the face of
the console. To remove the film, grasp the edge of it and peel it off the equipment.

Leveling the Treadmill

Important: Before using the treadmill, make sure it is completely level and that it sits
evenly on the floor.
To ensure that the treadmill is completely level, you should check it in two
directions:

from side to side (across the belt)

from front to back (along the belt)
The treadmill should be leveled to center or zero, depending on the type of level
you use. If adjustments are needed, adjust one rear foot at a time.
To check the level of the treadmill:
1. Place the level across the treadmill belt as shown in the following figure. Make
sure the level reads at center or zero, depending on the type of level you use.
Figure 23: Level position across belt
2. Place the level along the belt front to back as shown in the following figure.
Make sure the level reads at center or zero, depending on the type of level you
use.
Figure 24: Level position along belt
14