Precor TRM 800 Series Assembling And Maintaining Manual page 25

Assembling the Treadmill
2. Connect the new power harness as shown in the following
3. Using the Velcro connectors provided, attach the power
4. Route the DC output cable of the power supply through
5. Connect the black three-conductor plug on the AC wiring
In addition to the television and Ethernet cables, the P80
console packaging also includes an accessory jack panel that
you must install on the treadmill. This jack panel provides a
connection point between these two cables and the networks
at your facility.
figure and table.
Figure 6: P80 power harness connection points
Table 1. P80 power harness connections
Location Connector
Drive input connector
Brown lead with quick-connect terminal
Blue lead with quick-connect terminal
Green and yellow lead with quick-connect terminal
AC input connector for DC power supply
supply to the right-hand side of the front crossmember on
the treadmill base. Plug the AC input connector into the
socket on the power supply.
the cable ties behind the power supply, toward the
upright support on your right. Bend the cable ties over the
DC output cable to hold it in place.
harness to the socket on the power supply.
23