Installing the Console
5. Insert the edge of the rear cover into the lower edge of the
6. Fit the rear cover into place. Secure it using four ¹ ₄-inch ×
7. Tighten all six rear cover screws using a #3 Phillips
fairing. Lift the cover until it is possible to insert two
¹ ₄-inch × ³ ₄-inch self-tapping panhead screws into the
bottom two screw holes and partially tighten them.
Figure 33: Rear cover positioning
³ ₄-inch self-tapping panhead screws.
Figure 34: Rear cover attachment
Important: Make sure that all of the edges of the rear cover
are seated correctly and are flush with the surrounding panels
before you tighten the cover's mounting screws.
screwdriver.
47