Precor TRM 800 Series Assembling And Maintaining Manual page 39

Installing the Console
Table 2. P80 internal cable connections
Cable
Ethernet (LAN)
TV
Power
Data from base
unit
Heart rate sensors Four-contact strip, keyed
Safety key
(treadmills only)
CSAFE
To simplify installation and maintenance, route and connect
cables 1 through 5 according to the following instructions.
Note: In the illustrations in this section, some cables are
omitted for the sake of clarity.
Connecting the Television Cable
The console's television tuner is mounted inside the console's
back plate. The tuner includes a short cable adapter that
allows the television cable to be connected outside the back
plate.
To connect the television cable:
1.
2. Route the cable counterclockwise around the outside of
3. Attach the connector on the cable to the connector on the
Connector Type
Eight-contact modular, on
round black cable
F-type coaxial
Split power cable
Eight-contact modular, on
flat gray cable
Six-contact strip, keyed
Eight-contact modular, on
flat gray cable
Pull the cable out through the lower right corner of the
back plate.
the back plate.
Important: In the following step, one of the two wrenches
should be a torque wrench set to 30 in-lb.
tuner cable and tighten the two connectors securely using
two ⁷ ₁₆-inch open-end wrenches. Position both
connectors above the upper right corner of the back plate.
37
Circuit Connector
Location