Installation Requirements - Precor TRM 800 Series Assembling And Maintaining Manual

18
4. Lift the unit by placing hands on opposite sides of the rear
Before you begin, verify that you have received the following
parts:







Installation Requirements

The location where the treadmill is installed must provide
power connections that supply the appropriate voltage, a 20A
individual branch circuit, and grounding per NEC (National
Electric Code) guidelines or local region electric code.
CAUTION: Do not use a non-grounded outlet or transformer. Do
not remove or otherwise bypass the plug with an adapter.
Electrical damage can occur and void the Precor Limited Warranty
if the treadmill is connected to an improper power source.
Required Tools









Assembling and Maintaining TRM 800-Series Treadmills
cross brace found under the treadmill's running belt. Roll
the treadmill on its front wheels to the area where it will
be used.
Base frame assembly
Left and right upright supports
Center fairing with handrails
Hardware kit
Console
Personal Viewing System (PVS), if one was part of the
order
⁵ ₃₂-inch hex wrench (ball end hex wrenches are desirable)
³ ₁₆-inch hex wrench
⁷ ₃₂-inch hex wrench
³ ₄-inch open-end wrench
⁷ ₁₆-inch, 30 inch-pound (in-lb) torque wrench (if you are
installing a coaxial television cable)
Bubble level
#3 Phillips screwdriver
String or fish tape
Wire cutter