Completing The Console Installation (P30 And P10) - Precor TRM 800 Series Assembling And Maintaining Manual

Installing the Console
Completing the Console Installation (P30
and P10)
Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
To complete the installation:
1.
2. Tilt the control console backward (toward yourself) until
3. Insert four ¹ ₄-inch × ³ ₈-inch shoulder bolts through the
4. Line up the two small tabs at the bottom of the console's
5. Insert the two #8–32 × ¹ ₂-inch Phillips-head screws that
Feed any extra cable back into the treadmill fairing.
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
holes in the console mount and thread them into the holes
in the back plate on the console. Using a ³ ₁₆-inch hex
wrench, tighten the shoulder bolts completely.
Figure 30: Securing the console
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
you removed earlier into the holes at the top edge of the
console's back cover. Tighten the screws fully.
Important: If you are installing a console that is equipped
with a Personal Viewing System (PVS), use caution not to
pinch the cables between the back cover and PVS mounting
screw heads.
45