Precor TRM 800 Series Assembling And Maintaining Manual page 28

26
3. Route the upper end of the base unit data cable from the
4. Route the upper end of the console cable assembly from
Assembling and Maintaining TRM 800-Series Treadmills
top of the upright support on your left (shown as position
1 in the following figure) through the spacing ring
(position 2) and up through the cable channel on your left
(position 3). Bend the ends of the cable ties around the
data cable to hold it in place.
Figure 10: Base unit data cable positioning
the top of the upright support (position 1 in the following
figure) through the spacer ring (position 2) and the
right-hand cable channel in the fairing (position 3), then
wrap the ties next to the channel around the cable
assembly to secure it.
Figure 11: Console cable assembly positioning
Important: Do not wrench-tighten the fasteners in the
following step until the unit has been fully assembled. Make
sure the cables are not pinched between any fasteners and the
body of the equipment, or between the arm covers and the
upright supports. The Precor Limited Warranty does not cover
cables damaged by improper installation.