Reassembling The Treadmill Fairing - Precor TRM 800 Series Assembling And Maintaining Manual

46

Reassembling the Treadmill Fairing

After the console is in place, reattach the two cover panels of
the treadmill fairing.
Important: In the following procedure, do not allow the fasteners
to break or pinch any cables.
To reassemble the fairing:
1.
2. Install one of the access covers over the opening above
3. Secure the access cover with two ¹ ₄-inch × 1-inch
4. Repeat steps 2 and 3 to install the other access cover,
Assembling and Maintaining TRM 800-Series Treadmills
Verify that all cables are secure inside the cable ties.
the appropriate upright support. Slide the two tabs under
the edge of the opening as shown in the following figure.
Figure 31: Access panel positioning
buttonhead screws.
then tighten all four screws securely using a ⁵ ₃₂-inch hex
wrench.
Figure 32: Access panel attachment