Panasonic Strata Se General Description Manual page 16

STRATA Se/We
GENERAL DESCRIPTION
NOVEMBER 1987
HIOB: Provides one circuit to interface with ex-
ternal devices such as a voice mail port, an-
swering machine, standard telephone, mo-
dem, etc. Up to eight HlOBs (four on a
STRATA Se) may be installed on a system.
Each HI06 is connected to a proprietary sta-
tion port, reducing station capacity accord-
ingly.
Station Equipment
The principal components of the electronic
telephone are: handset, dial pad, speaker, micro-
phone, two volume controls, four fixed feature
buttons, an m button, and 9 or 19 flexible CO/
feature buttons. LED indicators are provided for
all buttons except for m and m. See Fig-
ures 10 and 12.
The single-line electronic telephone (Figure
9) is equipped with three permanently dedicated
buttons (mm=) and an Intercom/CO
line button, which is not labeled.
The lo-button Busy Lamp Field electronic
telephone (Figure 11) with speakerphone pro-
vides 10 buttons that can be assigned to control
intercom, CO line and feature operation, plus an
LED indication of which stations are in use.
A 20-button Liquid Crystal Display elec-
tronic telephone (Figure 13) with speakerphone
may be located at any or all of the stations. The
32-character alphanumeric display provides
many capabilities- an accurate clock/calendar
in its idle state; and elapsed time, dialed
number, calling station and CO line are just a
few of the features available. For additional ex-
planations of the features listed below, see Liq-
uid Crystal Display.
0 Al'phanumeric Messaging
l
Busy Station Messaging
e
l
Called Station Messaging
l
Calling Station Messaging
l
Remote Station Messaging
l
Busy Lamp Field (BLF) Indication
l
CO Line Identification
l
Speed Dial Memo
l
Timed Reminders
All phones are easily converted for wall
mounting, feature modular handset cords, are
equipped with a second modular connector for
headset connection (except the single-line), and
are connected to the system via modular line
cords.
-14-
An optional replacement base for the elec-
tronic telephone provides a built-in 300/1200
baud modem with automatic answering capabil-
ities. It is a Bell Standard, full duplex modem.
The optional door phone/monitor station
(Figure 6) allows distinctive ringing to pre-
selected station(s). When a station dials an indi-
vidual door phone, a circuit providing monitoring
capabilities on the intercom, is established. This
option requires station 13 and/or 14 (station 1 1
and/or 12 in STRATA Se) to be replaced by a
door phone control unit (HDCB) and up to six
door phone units (MDFBs)-three each HDCB.
One door phone/monitor (only station 13C for
Vle; 11 C for Se) can be replaced by an alarm
control circuit on station 13 HDCB and one by
a door lock control circuit on all HDCBs.
An external amplified speaker (HESB) may
be connected in any one of the following three
applications:
l
Loud Ringing Bell: Allows you to amplify
the tone of a paging/ringing signal without
using other manufacturers' equipment. The
signal can be amplified on all 6000-series
phones, except the single-line electronic tele-
phone. Three-pair wiring is required for this
application.
l
Amplified Speaker: Allows you to use the
HESB as a paging speaker, reducing the
need for other manufacturers' paging equip:
ment.
l
Talkback Amplified Speaker: Allows you to
provide a talkback speaker in areas where a
telephone is not needed. For talkback opera-
tion, connect the HESB to the door phone
unit (MDFB), which is used as a microphone;
however, the push-button is inoperative.
The HESB is a 6" 3-watt speaker with an
amplifier that is built into an attractive speaker
box (Figure 8). A +12 VDC power supply
(HACU-120), which connects to the back panel
via an 8' cord, is included with each HESB.
Installation
The key service unit is configured for wall
mounting only.
All external devices are connected to the
key service unit via connectors and terminals on
the side panels, as follows:
a) CO lines are connected to the key service
unit right side panel via separate (one for