Panasonic Strata Se General Description Manual page 116

PROGRAMMING PROCEDURES
SECTION 500-036-300
JANUARY 1988
TABLE 14
PROGRAM 06
AUTOMATIC RELEASE ON HOLD ENABLE
SET LED
on.
1) Lock in the SET switch on the HKSU.
Station 13/l 7 LED 19 on.
System is in program mode. ,
2) Depress the m key on station 13/l 7.
3) Dial a 1 on the dial pad.
Normal functions halt on station 13/l 7.
SPKR LED steady on.
SPKR LED flashes continuously.
CO LEDs indicate present data.
4) Refer to the System Record Sheet. An X on the record sheet means the LED should
Using the various keys, turn their associated be on (AROH enabled).
LEDs on or off, as required. Each CO key/LED If the LED is already on, depressing the associated
represents itself-that is, if LED 01 is on, CO1
key will turn it off and vice versa. LEDs may be
will have AROH during normal operation. If
turned off and on until the desired pattern is set.
k:f 01 is off, AROH will not function on that
5) Depress the m key to place new data in All station 13/17 LEDs (except 19) go off.
memory.
6A) Go to Step 2 in another program table
. . . or . . .
6B) Transfer data into working memory per Par-
agraph 02.06.
SET LED goes off.
Station 13/l 7 LED 19 goes off.
New data is stored, previous data is erased.
NOTES.
1. This program is used to release Trunk-to-Trunk connections if enabled with
Programs 02
and
0#6.
2. If Automatic Release from Hold is available, the CO will automatically drop the lines when the
outside party hangs up. However, if Automatic Release from Hold is not available, the person who
set up the trunk-to-trunk connection must occasionally monitor the call and disconnect the
CO
lines when the two parties hang up.
-4o-