Panasonic Strata Se General Description Manual page 131

TABLE 29
PROGRAM 104/106
OTHER COMMON CARRIER AUTHORIZATION CODE LENGTHS #l and #2
1) Lock in the
SET
switch on the HKSU.
2) Depress the m key on station 13/l 7.
3) Dial 0 =I(0 11) n the dial pad.
4) Refer to the System Record Sheet.
This program definesthe lengthsof the autho-
rization codes for OCC #l & #2. These 2-digit
numbers are entered via the dial pad.
SET LED on.
Station 13/17 LED 19 on.
,
System is in program mode.
Normal functions halt on station 13/17.
SPKR LED steady on.
SPKR LED flashes continuously.
The various LEDs indicate present data.
As each digit is entered, the entry is verified by
LEDs as shown below.
PROGRAMMING PROCEDURES
SECTION 500-036-300
JANUARY 1988
Key/LED/ Start )
1st Digit
2nd Diqit
Binary Numbers:
03
X = LED on
02
All LEDs off = no data
01
00
5) Depress the m key to place new data in
memory.
6A) Go to Step 2 in another program table
. . . or . . .
66) Transfer data into working memory per Par-
agraph 02.06.
All station 13/l 7 LEDs (except 19) go off.
New data is stored, previous data is erased.
SET LED goes off.
Station 13/l 7 LED 19 aoes off
r(m rc.
rl"IL.
Program 106
follows the same procedure as
Program 104.
Program 106
defines the length of OCC#2 authorization code.'
-55-