Panasonic Strata Se General Description Manual page 118

PROGRAMMING PROCEDURES
SECTION 500-036-300
JANUARY 1988
TABLE 16
PROGRAM 07
AUTOMATIC RELEASE ON HOLD TIMING
SET LED on.
1) Lock in the SET switch on the HKSU.
Station 13/l 7 LED 19 on.
System is in program mode. .(
2) Depress the m key on station 13/17.
3) Dial ii on the dial pad.
Normal functions halt on station 13/l 7.
SPKR LED steady on.
SPKR LED flashes continuously.
CO LEDs indicate present data.
4) Refer to the System Record Sheet. An X on the record sheet means the LED should
Using the appropriate keys, turn their asso- be on.
ciated LEDs on or off, as required. Each CO If the LED is already on, depressing the associated
key/LED represents itself-that is, if LED 01 key will turn it off and vice versa. LEDs may be
is on, CO1 will have Xl3 (crossbar) timing for turned off and on until the desired pattern is set.
AROH. If LED 01 is off,-CO1 will have ESS
(electronic) timing, etc.
5) Depress the m key to place new data in
All station 13/l 7 LEDs (except 19) go off.
memory.
6A) Go to Step 2 in another program table
. . . or . . .
68) Transfer data into working memory per Par-
agraph 02.06.
SET LED goes off.
Station 13/l 7 LED 19 goes off.
New data is stored, previous data is erased.
NOTE.
This program affects only those CO lines enabled via Program 06 (AROH should be enabled for
Trunk-to-Trunk connections).
-42-