Panasonic Strata Se General Description Manual page 117

PROGRAMMING PROCEDURES
SECTION 500-036-300
JANUARY 1988
TABLE 15
PROGRAM 0#6
TRUNK-to-TRUNK CONNECTION ENABLE
SET LED
on.
1) Lock in the
SET
switch on the HKSU.
Station 13/17 LED 19 on.
System is in program mode.
2) Depress the w key on station 13/l 7.
3) Dial 111 on the dial pad.
Normal functions halt on station 13/l 7.
SPKR LED steady on.
SPKR LED flashes continuously.
CO LEDs indicate present data.
4) Refer to the System Record Sheet.
An X on the record sheet means the LED should
Using the various keys, turn their associated be on.
LEDs
on or off, as required. Each CO key/LED
If the LED is already on, depressing the associated
represents itself-that is, if LED 01 is on, CO1
key will turn it off and vice versa. LEDs may be
will be allowed trunk-to-trunk connection, if
turned off and on until the desired pattern is set.
LED 01 is off, trunk-to-trunk connection will
not be allowed on that line, etc.
5) Depress the m key to place new data in
All station 13117 LEDs (except 19) go off.
memory.
6A) Go to Step 2 in another program table
or . . .
6B) Transfer data into working memory per Par-
agraph 02.06.
SET LED goes off.
Station 13/l 7 LED 19 goes off.
*New data is stored, previous data is erased.
-41-