Table of Contents
Advertisement
Table 30 Network > Wireless LAN > AP
LABEL
Cancel
Advanced
Setup
8.2.1 No Security
In the Network > Wireless LAN > AP screen, select No Security from the
Security Mode list to allow wireless devices to communicate with the P-660HN-
F1A without any data encryption or authentication.
Note: If you do not enable any wireless security on your P-660HN-F1A, your network
is accessible to any wireless networking device that is within range.
Figure 47 Network > Wireless LAN > AP: No Security
The following table describes the labels in this screen.
Table 31 Network > Wireless LAN > AP: No Security
LABEL
Security
Mode
8.2.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network >
Wireless LAN to display the AP screen. Select Static WEP from the Security
Mode list.
Note: WEP is extremely insecure. Its encryption can be broken by an attacker, using
widely-available software. It is strongly recommended that you use a more
effective security mechanism. Use the strongest security mechanism that all the
wireless devices in your network support. For example, use WPA-PSK or
P-660HN-F1A User's Guide
DESCRIPTION
Click this to restore your previously saved settings.
Click this to display the Wireless Advanced Setup screen and edit more
details of your WLAN setup. See
details.
DESCRIPTION
Choose No Security from the drop-down list box.
Chapter 8 Wireless LAN
Section 8.2.5 on page 151
for more
147
Advertisement
Table of Contents
