Table of Contents
Advertisement
Chapter 7 LAN Setup
7.5.1 Configuring the LAN IP Alias Screen
Use this screen to change your P-660HN-F1A's IP alias settings. Click Network >
LAN > IP Alias to open the following screen.
Figure 44 Network > LAN > IP Alias
The following table describes the labels in this screen.
Table 29 Network > LAN > IP Alias
LABEL
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
136
DESCRIPTION
Select the check box to configure another LAN network for the P-
660HN-F1A.
Enter the IP address of your P-660HN-F1A in dotted decimal notation.
Alternatively, click the right mouse button to copy and/or paste the IP
address.
Your P-660HN-F1A will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the P-660HN-F1A.
RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a
router to exchange routing information with other routers. The RIP
Direction field controls the sending and receiving of RIP packets.
Select the RIP direction from Both/In Only/Out Only/None. When
set to Both or Out Only, the P-660HN-F1A will broadcast its routing
table periodically. When set to Both or In Only, it will incorporate the
RIP information that it receives; when set to None, it will not send any
RIP packets and will ignore any RIP packets received.
P-660HN-F1A User's Guide
Advertisement
Table of Contents
