Wan Technical Reference; Encapsulation; Enet Encap; Ppp Over Ethernet - ZyXEL Communications P-660HN-F1A User Manual

802.11n wireless adsl2+ 4-port gateway
Hide thumbs Also See for P-660HN-F1A:
Table of Contents

Advertisement

Table 24 Network > Internet (WAN) > WAN Backup
LABEL
Metric
Backup Gateway
Apply
Cancel

6.5 WAN Technical Reference

This section provides some technical background information about the topics
covered in this chapter.

6.5.1 Encapsulation

Be sure to use the encapsulation method required by your ISP. The P-660HN-F1A
supports the following methods.

6.5.1.1 ENET ENCAP

The MAC Encapsulated Routing Link Protocol (ENET ENCAP) is only implemented
with the IP network protocol. IP packets are routed between the Ethernet interface
and the WAN interface and then formatted so that they can be understood in a
bridged environment. For instance, it encapsulates routed Ethernet frames into
bridged ATM cells. ENET ENCAP requires that you specify a gateway IP address in
the Gateway IP Address field in the wizard or WAN screen. You can get this
information from your ISP.

6.5.1.2 PPP over Ethernet

The P-660HN-F1A supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is
an IETF Draft standard (RFC 2516) specifying how a personal computer (PC)
interacts with a broadband modem (DSL, cable, wireless, etc.) connection. The
PPPoE option is for a dial-up connection using PPPoE.
P-660HN-F1A User's Guide
DESCRIPTION
This field sets this route's priority among the routes the P-660HN-
F1A uses.
The metric represents the "cost of transmission". A router
determines the best route for transmission by choosing a path
with the lowest "cost". RIP routing uses hop count as the
measurement of cost, with a minimum of "1" for directly
connected networks. The number must be between "1" and "15";
a number greater than "15" means the link is down. The smaller
the number, the lower the "cost".
Type the IP address of your backup gateway in dotted decimal
notation. The P-660HN-F1A automatically forwards traffic to this
IP address if the P-660HN-F1A's Internet connection terminates.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Chapter 6 WAN Setup
121

Advertisement

Table of Contents
loading

Table of Contents