Table of Contents
Advertisement
12.2.1 Editing Protocol Filters
Use this screen to display a protocol filter set on your P-660HN-F1A. Protocol rules
allow you to base the rule on the fields in the IP and the upper layer protocol, for
example, UDP and TCP headers.
In the Packet Filter screen, select Protocol Filter from the Filter Type field.
Then click the Edit icon from the Modify field to display the following screen.
Figure 89 Security > Packet Filter > Edit (Protocol Filter)
The following table describes the labels in this screen.
Table 62 Security > Packet Filter > Edit (Protocol Filter)
LABEL
#
Active
Filter Type
Protocol
SA
DA
Modify
Back
Apply
Cancel
P-660HN-F1A User's Guide
DESCRIPTION
This is the index number of the rules in a filter set.
Use the check box to turn a filter rule on or off.
This field displays whether the filter type is a protocol filter or generic
filter.
This field displays the upper layer protocol.
This field displays the source IP address.
This field displays the destination IP address.
Click the Edit icon to configure a filter rule.
Click the Remove icon to delete a filter rule.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 12 Packet Filter
219
Advertisement
Table of Contents
