Configuring The Lan Ip Alias Screen - ZyXEL Communications P-660HW-Tx v3 Series User Manual

Chapter 7 LAN Setup

7.5.1 Configuring the LAN IP Alias Screen

Use this screen to change your ZyXEL Device's IP alias settings. Click Network >
LAN > IP Alias to open the following screen.
Figure 43 Network > LAN > IP Alias
The following table describes the labels in this screen.
Table 28 Network > LAN > IP Alias
LABEL
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
128
DESCRIPTION
Select the check box to configure another LAN network for the ZyXEL
Device.
Enter the IP address of your ZyXEL Device in dotted decimal notation.
Alternatively, click the right mouse button to copy and/or paste the IP
address.
Your ZyXEL Device will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyXEL Device.
RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a
router to exchange routing information with other routers. The RIP
Direction field controls the sending and receiving of RIP packets.
Select the RIP direction from Both/In Only/Out Only/None. When
set to Both or Out Only, the ZyXEL Device will broadcast its routing
table periodically. When set to Both or In Only, it will incorporate the
RIP information that it receives; when set to None, it will not send any
RIP packets and will ignore any RIP packets received.
P-660HW-Tx v3 Series User's Guide