Removing The Handlebar; Checking The Handlebar; Installing The Handlebar - Yamaha RAPTOR YFM125RA Service Manual

EAS22860

REMOVING THE HANDLEBAR

1. Remove:
• Clutch switch "1"
TIP
Push the fastener when removing the clutch
switch out of the clutch lever holder.
2. Remove:
• Handlebar grip "1"
TIP
Blow compressed air between the left handle-
bar and the handlebar grip, and gradually push
the grip off the handlebar.
EAS22880

CHECKING THE HANDLEBAR

1. Check:
• Handlebar "1"
Bends/cracks/damage → Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS22911

INSTALLING THE HANDLEBAR

1. Install:
• Handlebar
• Handlebar holders
Handlebar holder bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
TIP
• Install the handlebar horizontally shown in
the illustration.
• The handlebar holder should be installed
with the punched mark "1" forward "2".
ECA2PA1403
First, tighten the bolts "3" on the front side
of the handlebar holder, and then the bolts
"4" on the rear side.
2. Install:
• Handlebar grips "1"
4-43
HANDLEBAR