Adjusting The Rear Brake Light Switch - Yamaha RAPTOR YFM125RA Service Manual

Speed limiter length
Less than 12 mm (0.47 in)
2. Adjust:
• Speed limiter length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the locknut "1".
b. Turn the adjusting screw "2" in or out until
the specified speed limiter length is
obtained.
Speed limiter length is
Direction "b"
decreased.
Speed limiter length is
Direction "c"
increased.
c. Tighten the locknut.
EWA14880
WARNING
• Particularly for a beginner rider, the speed
limiter should be screwed in completely.
Screw it out little by little as their riding
technique improves. Never remove the
speed limiter for a beginning rider.
• For proper throttle lever operation do not
turn out the adjusting screw more than 12
mm (0.47 in). Also, always adjust the
throttle cable free play to 2.0–4.0 mm
(0.08–0.16 in).
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS21330
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
TIP
• The rear brake light switch is operated by
movement of the brake pedal.
• The rear brake light switch is stepped on by
6–15 mm (0.24–0.59 in) adjusted when the
brake light comes on.
PERIODIC MAINTENANCE
1. Check:
• Rear brake light operation timing
Incorrect → Adjust.
Rear brake light operation tim-
ing
6–15 mm (0.24–0.59 in)
2. Adjust:
• Rear brake light operation timing
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Hold the main body "1" of the rear brake
light switch so that it does not rotate and
turn the adjusting nut "2" in direction "a" or
"b" until the rear brake light comes on at the
proper time.
Direction "a"
Brake light comes on sooner.
Direction "b"
Brake light comes on later.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS21780
REPLACING THE HEADLIGHT BULB
1. Disconnect:
• Headlight lead connectors "1"
2. Remove:
• Headlight bulb holder cover "2"
3. Remove:
• Headlight bulb holder "1"
• Headlight bulb "2"
3-25