Yamaha RAPTOR YFM125RA Service Manual page 53

1. Neutral indicator light lead
2. Front brake light switch lead
3. Main switch lead
4. Headlight lead
5. Brake hose
6. Starter motor lead
7. Battery negative lead
8. Parking brake cable
9. Rear brake light switch lead
10.Carburetor warmer lead
11.Air vent hose
12.Crankcase breather hose
13.Spark plug lead
14.Ignition coil
15.Throttle cable
16.Clutch cable
17.Wire harness
18.Clamp
19.Frame
20.Brake fluid reservoir hose
21.Carburetor overflow hose
22.Brake fluid reservoir cover
A. To the front panel
B. To the handlebar
C. To the front fender
D. Route the starter motor lead between the
engine mounting brackets.
E. Route the air vent hose between the brack-
ets.
F. Pass the throttle cable under the cross pipe
and left of the steering column as shown in
the illustration.
G. Pass the parking brake cable and the
clutch cable under the cross pipe and right
of the steering column as shown in the
illustration.
H. The clamp position should be at the center
between the engine mounting brackets.
I. Pass the rear brake light switch lead under
the engine mounting bracket on the right of
the vehicle.
J. Pass the rear brake light switch lead, air
vent hose, carburetor overflow hose, and
starter motor lead through the engine
mounting brackets.
K. Insert the clamp into the center hole of the
engine mounting bracket.
L. Pass the rear brake light switch lead next to
the rear brake reservoir cover.
M. Pass the battery negative lead on the top
of the engine mounting bracket.
2-30
CABLE ROUTING