Yamaha RAPTOR YFM125RA Service Manual page 202

Short clutch push rod locknut
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
11. Install:
• Clutch cover
Clutch cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Tighten the clutch cover bolts in the proper
tightening sequence as shown.
12. Install:
• Battery negative lead "1"
TIP
• When installing the battery negative lead,
clearance "a" between the top end of the bat-
tery negative lead terminal and the contour
of the clutch cover should be 3 mm (0.12 in)
or less.
• The angle of battery negative lead bend "b"
to inside should be 30 degrees angle or less.
The lead should not be bent outward.
13. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-10.
5-39
CLUTCH