Yamaha RAPTOR YFM125RA Service Manual page 143

TIP
• Before applying the adhesive, wipe off
grease or oil on the handlebar surface "a"
with a lacquer thinner.
• Install the handlebar grips so that the "L"
arrow on the left grip and "R" arrow on the
right grip are placed vertically.
3. Install:
• Handlebar switch "1"
• Clutch lever
• Clutch lever bracket "2"
Clutch lever bracket bolt
4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
TIP
• Install the clutch lever bracket as shown.
• Install the clutch lever "3" at 10 degrees
angle as shown.
a. 53–54 mm (2.09–2.13 in)
4. Install:
• Throttle lever assembly
• Spacer
• Brake master cylinder
Brake master cylinder bracket
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Engage the indentations "a" in the spacer
with the lobes "b" on the throttle lever assem-
bly and brake master cylinder.
• The "UP" mark on the brake master cylinder
bracket should face up.
• Install the brake lever "1" at 10 degrees angle
as shown.
5. Install:
• Clutch switch
• Front brake light switch
6. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-10.
Clutch cable free play
5.0–10.0 mm (0.20–0.39 in)
7. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" on page 3-24.
4-44
HANDLEBAR