Yamaha RAPTOR YFM125RA Service Manual page 59

1. Air vent hose
2. Clamp
3. Starter motor lead
4. AC magneto lead
5. Carburetor overflow hose
6. Frame
7. Seat pad
8. Wire harness
9. Battery negative lead
10.Rear brake light switch lead
11.Carburetor warmer lead
12.Side cover
13.Crankcase breather hose
14.Air filter joint
15.Engine mounting bracket
A. To the front fender
B. Fix point for wire harness
C. Clamp near the hook of the air filter.
D. Clamp near the edge of the air filter case.
E. Pass the AC magneto lead through the
guide of the drive sprocket cover.
F. Clamp the starter motor lead at the center
hole of the engine mounting bracket.
G. Clamp the starter motor lead at the hole on
the engine side of the engine mounting
bracket.
H. Pass the clamp through the frame bracket.
I. Place the couplers on the inside of the side
cover.
J. Route the leads on the upper inside of the
side cover
2-36
CABLE ROUTING