Installing The Swingarm - Yamaha RAPTOR YFM125RA Service Manual

EAS23380

INSTALLING THE SWINGARM

1. Lubricate:
• Bearings
• Spacer
• Oil seals
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
• Spacer "2"
• Oil seals New
• Dust covers
TIP
Inject the bearing with the character stamp
turned outward.
Installed depth of bearing "a"
1–2 mm (0.04–0.08 in)
3. Install:
• Pivot shaft
Pivot shaft nut
100 Nm (10 m·kgf, 72 ft·lbf)
4. Install:
• Rear shock absorber assembly
• Rear axle hub
• Rear axle
• Rear wheel
Refer to "REAR WHEEL" on page 4-10,
"REAR SHOCK ABSORBER ASSEM-
BLY" on page 4-53 and "REAR AXLE
AND REAR AXLE HUB" on page 4-12.
5. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE
CHAIN SLACK" on page 3-17.
Drive chain slack
45.0–55.0 mm (1.77–2.17 in)
4-57
SWINGARM