Yamaha RAPTOR YFM125RA Service Manual page 216

5. Install:
• Stator coil
• Stator coil lead holder
• Pickup coil
Stator coil bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
Stator coil lead holder screw
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Pickup coil bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
6. Install:
• Dowel pin
• Generator rotor cover gasket
• Generator rotor cover
TIP
Tighten the generator rotor cover bolts in the
proper tightening sequence as shown.
Generator rotor cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
7. Install:
• Neutral switch lead "1"
TIP
Route the neutral switch lead as shown in the
illustration, and then apply sealant (Three
bond 7738) to affix the lead to the generator
rotor cover at the locations "a".
GENERATOR AND STARTER CLUTCH
New
5-53