Installing The Rear Brake Caliper - Yamaha RAPTOR YFM125RA Service Manual

Recommended fluid
DOT 4
1. Install:
• Brake caliper piston seal "1"
• Brake caliper piston dust seal "2"
2. Install:
• Brake caliper piston "1"
3. Install:
• Parking brake arm "1"
4. Measure:
• Parking brake arm to parking brake
bracket distance "a"
Out of specification → Adjust.
Parking brake arm to parking
brake bracket distance
73.3 mm (2.89 in)
EAS22670

INSTALLING THE REAR BRAKE CALIPER

1. Install:
• Brake caliper "1"
New
• Copper washers "2"
• Brake hose "3"
New
• Union bolt "4"
EWA13530
WARNING
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING" on page 2-27.
ECA2PA1404
When installing the brake hose onto the
brake caliper "1", make sure the brake pipe
touches the projection "a" on the brake cal-
iper.
2. Remove:
• Brake caliper
3. Install:
• Brake pads
• Brake pad spring
• Lock washer
• Brake pad retaining bolts
• Brake caliper
• Brake caliper bolts
4-38
REAR BRAKE
(temporarily)
New
Brake hose union bolt
31 Nm (3.1 m·kgf, 22 ft·lbf)
New
Refer to "REPLACING THE REAR
BRAKE PADS" on page 4-35.
Brake pad retaining bolt
17 Nm (1.7 m·kgf, 12 ft·lbf)
Brake caliper bolt
34 Nm (3.4 m·kgf, 25 ft·lbf)